UFH GUIDE · PUTNEY
Engineered oak flooring over underfloor heating in Putney
UFH and wood flooring is where most Putney installs go wrong, because the rules differ from manufacturer to manufacturer and the consequences (cupping, gapping, delamination) only show up months later. Putney's interwar semis frequently have parquet hidden under carpet, which we often lift, sand and re-finish rather than replace. This page covers exactly how we fit engineered wood flooring over UFH for Putney homes — temperature ramps, underlay tog, and which products are actually rated for the heat output you've got.
What matters for engineered wood flooring in Putney
- Maximum surface temperature for any wood floor is 27°C — Putney new-build manifolds often run hotter and need a thermostat cap.
- Underlay tog should sit under 0.5 — anything thicker insulates the heat back into the screed instead of the room.
- Screed must read below 1.8% CM moisture before any wood goes down. We bring our own meter to every Putney survey.
- A 14-day temperature ramp (start cold, +5°C per day) protects the boards and the joints during commissioning.
- Engineered planks are dimensionally stable, so they suit UFH and wide-plank installs that solid wood can't reliably handle.
Typical Putney use cases
Wet UFH on screed in Putney
Default spec: 14–15mm engineered oak, glue-down, low-tog underlay or fully bonded.
Electric UFH retrofit
Lower output — most engineered oak specs are still safe, but we check the wattage per m² before quoting.
Putney kitchen extension
UFH in the new section, joist construction in the old — we plan an expansion break at the transition.
Nearby areas we cover
We fit engineered wood flooring across Putney and the surrounding area, including:
Putney is part of our wider London coverage — see all services and areas there.
Putney FAQs
- Can I fit solid wood over UFH in Putney?
- We don't recommend it. Solid moves too much with temperature swing — engineered oak gives you the same look with proper stability.
- What's the right underlay for UFH in a Putney flat?
- Something under 0.5 tog, ideally a fully bonded adhesive. We use Sika Bond or F. Ball depending on the screed.
- How long after the UFH is commissioned can you fit?
- Minimum 14 days after final screed temperature, with documented moisture readings under 1.8% CM.
- Do you cover Putney for UFH installs?
- Yes — and the surrounding Barnes, Roehampton, Wandsworth area. UFH installs are one of our most common Putney jobs.
Summary
Engineered oak over UFH in Putney is fine — but only with the right spec, the right underlay, and the right ramp. We do all three in writing before fitting.
More Putney-area guides
COST GUIDE
Engineered oak flooring cost in Kensington (2026 guide)
COST GUIDE
Engineered oak flooring cost in Hackney (2026 guide)
COST GUIDE
Engineered oak flooring cost in Wandsworth (2026 guide)
COST GUIDE
Restoration flooring cost in Putney (2026 guide)
COST GUIDE
Engineered oak flooring cost in Wimbledon (2026 guide)
COST GUIDE
Engineered oak flooring cost in Woking (2026 guide)
BOOK YOUR FREE SURVEY
READY TO
FIT YOUR DREAM FLOOR?
Our flooring experts are here to help. Book a free on-site survey and get a no-obligation quote within 48 hours.
Get Free Quote →