UFH GUIDE · RICHMOND
Luxury vinyl flooring over underfloor heating in Richmond
UFH and wood flooring is where most Richmond installs go wrong, because the rules differ from manufacturer to manufacturer and the consequences (cupping, gapping, delamination) only show up months later. Many Richmond properties are in conservation areas, so we keep skirting profiles original and avoid bulky transition strips. This page covers exactly how we fit luxury vinyl flooring over UFH for Richmond homes — temperature ramps, underlay tog, and which products are actually rated for the heat output you've got.
What matters for luxury vinyl flooring in Richmond
- Maximum surface temperature for any wood floor is 27°C — Richmond new-build manifolds often run hotter and need a thermostat cap.
- Underlay tog should sit under 0.5 — anything thicker insulates the heat back into the screed instead of the room.
- Screed must read below 1.8% CM moisture before any wood goes down. We bring our own meter to every Richmond survey.
- A 14-day temperature ramp (start cold, +5°C per day) protects the boards and the joints during commissioning.
- LVT and SPC need a dead-flat subfloor — any dip over 3mm telegraphs through within months, so latex screeding is usually included in our quotes.
Typical Richmond use cases
Wet UFH on screed in Richmond
Default spec: 14–15mm engineered oak, glue-down, low-tog underlay or fully bonded.
Electric UFH retrofit
Lower output — most luxury vinyl specs are still safe, but we check the wattage per m² before quoting.
Richmond kitchen extension
UFH in the new section, joist construction in the old — we plan an expansion break at the transition.
Nearby areas we cover
We fit luxury vinyl flooring across Richmond and the surrounding area, including:
Richmond is part of our wider London coverage — see all services and areas there.
Richmond FAQs
- Can I fit solid wood over UFH in Richmond?
- We don't recommend it. Solid moves too much with temperature swing — engineered oak gives you the same look with proper stability.
- What's the right underlay for UFH in a Richmond flat?
- Something under 0.5 tog, ideally a fully bonded adhesive. We use Sika Bond or F. Ball depending on the screed.
- How long after the UFH is commissioned can you fit?
- Minimum 14 days after final screed temperature, with documented moisture readings under 1.8% CM.
- Do you cover Richmond for UFH installs?
- Yes — and the surrounding Kew, Twickenham, East Sheen area. UFH installs are one of our most common Richmond jobs.
Summary
Luxury vinyl over UFH in Richmond is fine — but only with the right spec, the right underlay, and the right ramp. We do all three in writing before fitting.
More Richmond-area guides
COST GUIDE
Luxury vinyl flooring cost in Notting Hill (2026 guide)
COST GUIDE
Luxury vinyl flooring cost in Shoreditch (2026 guide)
COST GUIDE
Luxury vinyl flooring cost in Fulham (2026 guide)
COST GUIDE
Solid wood flooring cost in Richmond (2026 guide)
COST GUIDE
Luxury vinyl flooring cost in Greenwich (2026 guide)
COST GUIDE
Luxury vinyl flooring cost in Esher (2026 guide)
BOOK YOUR FREE SURVEY
READY TO
FIT YOUR DREAM FLOOR?
Our flooring experts are here to help. Book a free on-site survey and get a no-obligation quote within 48 hours.
Get Free Quote →