UFH GUIDE · WOKING
Restoration flooring over underfloor heating in Woking
UFH and wood flooring is where most Woking installs go wrong, because the rules differ from manufacturer to manufacturer and the consequences (cupping, gapping, delamination) only show up months later. Woking's 1980s estates often have screed with hairline cracks — we lay a fibreglass-reinforced SLC before any wood install. This page covers exactly how we fit floor restoration over UFH for Woking homes — temperature ramps, underlay tog, and which products are actually rated for the heat output you've got.
What matters for floor restoration in Woking
- Maximum surface temperature for any wood floor is 27°C — Woking new-build manifolds often run hotter and need a thermostat cap.
- Underlay tog should sit under 0.5 — anything thicker insulates the heat back into the screed instead of the room.
- Screed must read below 1.8% CM moisture before any wood goes down. We bring our own meter to every Woking survey.
- A 14-day temperature ramp (start cold, +5°C per day) protects the boards and the joints during commissioning.
- We dust-extract sand on site so you can stay in the property; gaps are filled with resin-and-sawdust slurry matched to the boards before staining.
Typical Woking use cases
Wet UFH on screed in Woking
Default spec: 14–15mm engineered oak, glue-down, low-tog underlay or fully bonded.
Electric UFH retrofit
Lower output — most restoration specs are still safe, but we check the wattage per m² before quoting.
Woking kitchen extension
UFH in the new section, joist construction in the old — we plan an expansion break at the transition.
Nearby areas we cover
We fit floor restoration across Woking and the surrounding area, including:
Woking is part of our wider Surrey coverage — see all services and areas there.
Woking FAQs
- Can I fit solid wood over UFH in Woking?
- We don't recommend it. Solid moves too much with temperature swing — engineered oak gives you the same look with proper stability.
- What's the right underlay for UFH in a Woking flat?
- Something under 0.5 tog, ideally a fully bonded adhesive. We use Sika Bond or F. Ball depending on the screed.
- How long after the UFH is commissioned can you fit?
- Minimum 14 days after final screed temperature, with documented moisture readings under 1.8% CM.
- Do you cover Woking for UFH installs?
- Yes — and the surrounding Horsell, Knaphill, Byfleet area. UFH installs are one of our most common Woking jobs.
Summary
Restoration over UFH in Woking is fine — but only with the right spec, the right underlay, and the right ramp. We do all three in writing before fitting.
More Woking-area guides
COST GUIDE
Restoration flooring cost in Hampstead (2026 guide)
COST GUIDE
Restoration flooring cost in Clapham (2026 guide)
COST GUIDE
Restoration flooring cost in Putney (2026 guide)
COST GUIDE
Restoration flooring cost in Dulwich (2026 guide)
COST GUIDE
Engineered oak flooring cost in Woking (2026 guide)
COST GUIDE
Restoration flooring cost in Cobham (2026 guide)
BOOK YOUR FREE SURVEY
READY TO
FIT YOUR DREAM FLOOR?
Our flooring experts are here to help. Book a free on-site survey and get a no-obligation quote within 48 hours.
Get Free Quote →